BridgeLINK-Pro™ Installation Guide
Page 8
© 2003 - RadioLAN Marketing Group, Inc.
AC Power Adapter
AC Power Adapter
The supplied power adapter provides an easy connection to standard AC electrical outlets. The adapter
plugs into the PoE Adapter’s power jack. RMG recommends using a non-switched electrical outlet to
power the BPU.
The output from the BridgeLINK -Pro power adapter is 10VAC to 18VAC, depending on the length of the
Ethernet Cable between the PoE Module and the BPU. You may use older AC or DC power transformers
from the original BridgeLINK or BridgeLINK -II to power the BridgeLINK-Pro, as the unit will run on DC
power. However, we recommend that you use only the AC Power transformer supplied with the
BridgeLINK -Pro unit, or contact RMG for a suitable replacement power adapter.
PoE Adapter
PoE Adapter
The PoE adapter module has three connectors: one for power, one for a
connection to the BPU, and one for connection to the Ethernet Equipment. It
is very important to properly connect the PoE adapter. The Input ports are
labeled
Net
and
Power
, and the output to the BPU is labeled
ODU
. The PoE
adapter is designed for easy mounting on the wall.
Caution: The BPU port carries AC power and may damage Ethernet equipment
erroneously plugged into it. Make sure that only the BPU is connected to this
port. Failure to do so will void the warranty. RadioLAN assumes no liability for
damage to any equipment due to failure to follow these instructions.
PoE Injector Module
Summary of Contents for BridgeLINK-Pro
Page 2: ......
