Install Guide CT32
Caution
• Your thermostat is a precise instrument, handle it with care.
• Turn off electricity to the HVAC system before installing or
servicing thermostat or any part of the system.
• Do not turn electricity back on until work is completed.
• Do not short (jumper) across electric terminals at the control
on the furnace or air conditioner to test the system. This may
damage the thermostat.
• All wiring must conform to local codes and ordinances.
• This thermostat is designed for use with 24 volt AC HVAC
and millivolt gas systems. The thermostat is powered by 4AA
alkaline batteries and/or 24 volt AC C wire (or a 12-24 AC or
DC source). Each thermostat relay load should be limited to 1.0
amp; higher amperage may cause damage to the thermostat.
Caution
To avoid electrical shock and
to prevent damage to the furnace, air conditioner, and
thermostat,
disconnect the power supply
before
beginning work. This can be done at the circuit breaker.
Save
Energy
button
Power Grid
status
indicator
top cover
Touch screen
Wire
terminal
Mode
button
MENU
button
Reset
HVAC
selections
switches
bottom
cover
1202-003-006
INSTALLATION
ENGLISH