Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
Thank you for purchasing your Mini RC Train
from RadioShack.
60-1256
Silver Line RC Train
Controller
Curve tracks (8)
Straight Tracks (5)
Divert Track Switch (1)
Connecters (18)
Signal lights (2)
Charging Garage (1)
End Track pole - snaps into Straight Track (1)
Sound and light station (1)
Locomotive (1)
Passenger Car middle (1)
Passenger Car end (1)
Note: Actual product may vary from the images found in this
document.
1. Remove the battery compartment cover and
replace when fi nished.
2. Install one 9V alkaline battery as indicated by
the polarity symbols (+ and -) marked inside.
3. Repeat these steps to install batteries in the
Charging Station (three AA alkaline batteries)
and Train Station (three AA alkaline batteries).
Charge the locomotive before using
it the fi rst time.
Controller
Locomotive Passenger cars
Light and Sound
Train Station
Signal Light
Recharging
Garage
End Track
Train Station
On/Off
Switch
On/Off
Switch
Locomotive
On/Off Switch
Forward
Switch 2
(for backing
onto endtrack)
On/Off
Switch 1
(for driving
into charging
station)
Reverse
Stop
Charging Garage
Charging Your Train
When your train slows down it needs to
be recharged.
Signal Light
1. Turn and hold the Switch
on the Controller to Switch 1
2. The divert track switch at the
intersection lets the train
drive into the charger
4. The red indicator
lights up to show the
engine is charging.
3. To charge the engine,
press down the Charging
Button when the engine
is in the Charging Garage.
5. The green light indicates
charging is complete.
Track Connector
6. Press the release button
to release the engine.
Setting Up
1. Assemble the train track as shown
above
2. Turn on each piece in the order below.
3. Set the locomotive
on the track and
connect the cars.
4. Use the forward and
reverse switches on
the controller to move
the train.
NOTE