9
5. Insert the tabs on the narrow end of
the bracket into the upper slots on
the bottom of the base, then push
the tabs on the wide end of the
bracket into the lower slots on the
bottom of the base.
6. Plug the short modular cord into the
wall plate jack, align the base’s key-
hole slots with the wall plate studs,
and slide the base downward to
secure it.
7. Plug the adapter into a standard AC
outlet.
8. Lift the base’s antenna to a vertical
position.
MOUNTING THE BASE
DIRECTLY ON THE WALL
For this mounting method, you need two
flat-head screws (not supplied) with
heads that fit into the keyhole slots on
the mounting bracket.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend
about
3
/
16
inch (5 mm)
from the wall.
2. Remove the bracket by holding in
both tabs and gently pulling out the
wide end of the bracket.
3. Plug one end of the supplied long
modular cord into the phone jack on
the back of the base. Route the
modular cord through the left slot on
the bottom of the base and pull the
cord down to remove any slack on
top.
3
15
/
16
"
3
/
16
"
Phone Jack
43-1089.fm Page 9 Tuesday, August 17, 1999 3:24 PM
