Radical Sportscars SR3 XX, Owner'S Manual, Page: 21 / 56

21
5. WORKSHOP CAR MAINTENANCE
After every day the car has run the car should be inspected thoroughly in a workshop environment.
5.1 LIFTING YOUR CAR
A I R J A CK S
In order nto the fitting as shown in the picture below. Slowly build
up the pressure in the regulator, until the car is fully off the ground. (250-300psi)
Before working on the car, the air jack safety clamps must be inserted, to do this simply push the open side of
the yellow clamp around each of the three air jacks as shown until they click on.
To release the air jacks, ensure it is safe to do so, then pull back on the fitting shown in the picture. Slowly
pull the fitting to gradually release the pressure in the system, pulling it quickly will result in the car dropping
to the ground rapidly. It is advised to leave the fitting on the open position when it is empty so that the system
cannot re-pressurise.