Page1
LCD symbols
Symbol
Event
The buttons are locked
Heating is turned on
Zone number
Program number
Symbol
AUTO
Er
Automatic mode,
executes the programmed schedules
Event
Temporary temperature override
Increase
The floor sensor is not being read by the thermostat
OVERRIDE
Decrease
Manual mode
1,2,3,4
1,2
ver 1.0
GTS-DUAL-V Thermostat
Timer Instructions
Configuration Menu
To enter into the setting menu please follow the steps below:
Step 1
, Turn the thermostat off by pressing ;
Step 2
, Press , you will then see menu 1. At this step, if you press and hold “MENU”, you will access to MENU 4 directly.
Step 3
, Use the up and down arrows to adjust the “sensor selection” which is Menu 1(Air sensing, Air and Floor, or Floor only)
Step 4
, Press to move to the next menu and once you have all the menu options set,
Setp 5
, Press to accept and store.
Menu # Feature
Explanation
Adjustment
（
press up & down buttons to adjust
）
4
Reset
This allows you to reset your thermostat to factory default
Press and hold down button until you see RES on screen
1
Mode/Sensor selection(Zone 1 only)
This thermostat is a combination model which allows you to
choose 3 different modes.
A mode=Air Sensing Only(Has built in sensor)
AF mode=Air & Floor sensing(Floor probe must be installed)
F mode=Floor Sensing(Floor probe must be installed)
A, AF, F (F by default)
2
Maximum Floor Temp
( AF mode only) (Zone 1 only)
This is to protect the floor surface.
20 °C~ 40 °C (40 °C by default)
3
5+2 / 7 Day Mode
This allows you to program either 5 days at once, then the 2
days of the weekend separately, or a full 7 days at the same
time or 7 days separately
01 = 5+2 day programmable
02 = 7 day programmable
OK
POWER
NEXT
MENU
Setting the clock and day of the week
This thermostat is fitted with a real time clock. It is essential that the clock time and day are set accurately if you require your programmed events to start
on time. To set follow the steps below:
Touch and the time will start flashing. Use the up and down arrows to set the time.By holding the arrow down the time will change faster.
Press
to move to the Day setting and use the up and down arrows to get to the correct day.
Press
to store and exit.
1
2
3
OK
NEXT
TIME
Alternating the Zones
In order to alternate between the zones you should press and hold , the LCD will display ZONE 1 or ZONE 2 at top right corner.
TIME
Turning On/Off the Thermostat
Press to turn on/off the thermostat. When thermostat is turned off
，
the LCD will display OFF. The outputs for all zones will be turned off.
POWER
When your thermostat is first connected to mains power, wait for about 30 seconds until the touch pad has self-adjusted.
