20
7. Troubleshooting
If the device does not start:
•
Make sure that the power cord is connected into the wall electrical outlet�
•
Check the fuse inside the fuse drawer� Replace fuse if blown (see instructions on
Fuse Replacment section)�
•
If a pulse sequence is not released when pressing the Pulse Switch:
•
Gently press the Handpiece opening onto the skin and listen for the audio signal�
If there is no audio signal, contact FSD Plus service center�
•
The device might be overheated� Turn off the device for 30 minutes to allow it to
cool down�
•
If the pulse rate within a sequence slows down or if the charging and ready indicators
turn on and off repeatedly, the device may be overheated� Turn off the device for 30
minutes to allow it to cool down�
•
If at any point the device goes into charging mode for longer periods, this is due to
an internal safety mechanism that monitors the LUA temperature and is designed to
avoid over-heating� Wait until the ready indicator light turns on again, and only then
replace the handpiece on the skin�
•
If any problem persists, contact FSD Plus service through Radiancy or your point of
purchase�
Radiancy is responsible for the effects on safety, reliability and performance of the
equipment only if repairs are carried out by Radiancy authorized personnel�
