RADEMACHER Troll Basic DuoFern 5615, Instruction Manual, Page: 34 / 40

34
i
EN 21. Venetian blinds mode; brief description
This function enables you to use the Troll Basic DuoFern to control Venetian blinds. The Venetian
blinds mode can also be switched on/off by an overriding DuoFern controller (e.g. HomePilot®).
The following modes are possible:
◆ Jog mode
◆
Automatic wind function / tilting time
Additional Venetian blinds functions can be configured, for example, with a
HomePilot®:
◆
Standard slat position
◆ Automatic tilt after manual stop in direction "Down"
◆
Auto tilt to sunshine position
◆
Auto tilt to ventilation position
◆ Automatic tilt after moving to a target position
◆
Slat run time
◆
Motor dead time
Brief description of jog mode, see page 20.
Briefly tapping the operating buttons enables Venetian blinds slats to be conveniently
configured.
NOTE
Pressing the respective operating key
[ Up / Down ]
for an extended period causes the Troll
Basic DuoFern to automatically move the Venetian blinds to the corresponding end position.
Brief description of automatic slat adjustment function
If the Troll Basic DuoFern controls the Venetian blinds motor in the down direction until the
total running time has elapsed or the Venetian blinds motor is stopped manually, then the motor
reverses automatically for a brief period (automatic slat adjustment). This serves to position
the slats to the desired angle, in order to provide sun shading to the room.
The slat position can also be configured by a registered DuoFern controller (e.g. HomePilot®
or DuoFern manual central operating unit).