16
i
1.
2.
3.
EN
13. Assembly
The SpeedTimer is intended for flush-mounting. We recommend
using a deep box.
You will need:
1 x 58mm flush-mounted box
Installation procedure:
1.
Switch off the mains.
2.
make the electrical connection according to the wiring diagram
(see page 15).
3.
Route the power cables to the flush-mounted box.
4.
Slide the installation housing
(3)
into the flush-mounted box and
screw in place with the screws.
5.
Fit the frame
(2)
.
6.
carefully insert the operating unit
(1)
into the installation
housing
(3)
.
7.
Switch the mains power again back on again.
