61
EN
A software reset must be carried out to reset the DuoFern Wall
Controller to the original factory settings.
13. Deleting all settings, software reset
1.
Simultaneously press buttons
TL + T2
until the red LED lights up red
continuously after initially
flashing.
i
14. Dismantling
1.
Carry out a software reset to log off all DuoFern devices from
the DuoFern Wall Controller.
2.
Carefully pull the operating unit and then the frame out of the
wall bracket.
3.
Remove the wall bracket from the wall.
4.
If required, remove the battery from the DuoFern Wall
Controller.
i
2.
All settings have been deleted and reset to the original factory
settings. All logged on DuoFern devices have been automatical-
ly logged off.
