Default = 120
RSS (Received Signal Strength) limit for access to Radio channel. RipEX does not start
transmitting when a frame is being received and the RSS is better than the set limit or when
the destination MAC address of the frame is its own.
Repeat COM Broadcast
List box: On, Off
Default = Off
If On, a broadcast originated on COM port (Protocol/Broadcast = On) in any remote unit and
received by this unit on Radio channel is repeated to Radio channel.
Advanced parameters
Individual link options
It is possible to set certain Radio protocol parameters individually for a specific radio hop.
The Radio hop is defined by a record in the table. General settings as above are used
for radio hops, which are not defined in this table.
Counterpart Radio IP
Radio IP address of RipEX on the opposite site of radio hop.
Note
You may add a note to each address with your comments up to 16 characters (UTF8
is supported) for your convenience. (E.g. " Remote unit #1 " etc.). Following characters
are not allowed:
" (Double quote)
` (Grave accent)
\ (Backslash)
$ (Dollar symbol)
; (Semicolon)
Active
You may tick/un-tick each line in order to make it active/not active.
Retransmission settings
An advanced user can modify the frame retransmission protocol parameters in this menu
in order to optimize the network throughput under specific load. This menu is accessible
only when parameter "ACK" is "On" and and "Retries [No]" is greater than zero.
The retransmission timeout is calculated as follows (see below for details):
Rt = Ft + [0..Mv] * Vt + Prog
Where:
Rt – Retransmission timeout
Ft - time defined by the "Fix timeout [bytes]"
Vt - time defined by the "Variable timeout [bytes]"
Prog – zero when
"Progressivity" is "Off"
123
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration
Summary of Contents for RipEX
Page 2: ......
