RACOM Ray2, User Manual

Page: 70 / 235

7.4.3. Service access
Services
Access routes for link configuration.
Fig. 7.9: Menu Link settings – Service access – Services
There are two modes of accessing the internal management system of the microwave
link: standard and direct Service
channel
standard:
Both units are configured with the separate IP addresses, Netmasks, Gateways and
Management VLANs. IP addresses of both units doesn't have to belong in to the
same sub-net. The
Internal VLAN is required to encapsulate the internal service traffic
between both units of the microwave link. There are additional internal service ad-
dresses used for this internal service traffic (see
IPv4 address - Local section for
further details).
direct:
Both units are configured with the separate IP addresses but with the same Netmask,
Gateway and the Management VLAN . IP addresses of both units must belong in
RAy2 Microwave Link – © RACOM s.r.o. 70
Configuration