RACOM Ray2, User Manual

Page: 61 / 235

7. Configuration
7.1. Introduction
Controls
The following configuration buttons are used for configuration:
Apply and save parameters. Apply
Set parameters are overwritten with original values. Cancel
Reload the current values of the unit / both units. Refresh
Show values of individual parameters as they are stored in backup configuration (in
the buffer). To use any of these values, you must use the
Apply button.
Show defaults
Clicking the button displays the values of individual parameters held in the backup
file (
Backup – Settings – Open file upload ). To use any of these values, you must use
Show backup
the Apply button. For loading the backup configuration see menu Tools – Maintenance
– Backup .
Automatic refresh is performed once every 30 sec. Activating automatic refresh using
the
Start button increases the frequency of this function. Information subject to this
update is highlighted with a refresh icon.
Use the
Refresh button for reload of current values.
Start
Use the Stop button to stop automatic refresh of displayed information. Stop
Fig. 7.1: Info Refresh
Help
The microwave link configuration system is equipped with built in Help - see Help section. The Help is
accessible in two forms:
• Configuration parameter context help. The help text is displayed in the pop up window after clicking
the parameter name.
• The whole user interface help. The help text is displayed within the configuration screen after
clicking the
Help menu.
Secure login
You can login into the configuration interface using either the insecure http protocol (default login
screen), or the secure https protocol. You should select the connection method on the login screen.
If the https protocol is used, it is not possible to tap the network communication and acquire the station’s
login information.
61 © RACOM s.r.o. – RAy2 Microwave Link
Configuration