910500
– 4-Cycle Gas Power
Impact Wrench
Impact
Phone: (262) 637-9681
Email:
5.2022 Rev 1
Page
15
of
27
Operation
When increasing the engine speed, operate the throttle slowly. If operating too fast may cause
unexpected accidents.
Operate engine with both hand on the machine.
Once starting the engine, do not leave the tool alone
. Always hold handle
tightly so that tool will not move around on the stand or floor
Before and during operation, always take a firm stance and keep safety
position from slipping or falling.
•
Do not touch the spark plug cable and the spark plug cap during engine operation. There is risk of
electric shock.
•
Do not touch rotating parts. It is very dangerous and may cause injury.
•
Do not run idle with the accessory tool attached.
•
Check the direction of rotation before starting the product.
•
Be sure to stop the engine when stopped or when changing the tools and parts.
•
Do not touch the tools and screws during operation because they are hot due to friction.
•
Engine and other parts become hot. Do not touch anything other than the handle or the operation
unit.
•
If an abnormal occurs, stop the engine immediately and stop the work.
Torque Adjustment
The impact wrench has full throttle mode and
half throttle mode by pushing the adjustment
button.
Make fine adjustments using the adjustment
switch during half throttle.
[ 1 ] is maximum
[ 3 ] is minimum.
Socket Installation
There is a pin hole at the end of the anvil (drive).
This have to be aligned with the pin hole of the socket and secured with the pin and O-ring.
Personal Injury.
If the socket is not securely installed, the socket may come
off and pop out, causing injury. Never run idle with a socket.
