IQ3 Street Logger Dash Installation Manual
43
Example Warning Setup
As noted in the previous section, the dash warning setup allows the user to trigger a warning light based on
one sensor channel or two sensor channels. In addition, a specific text warning may be programmed to
display when the warning parameters are met.
In the example setup below, the dash warning was programmed as follows:
Warning Channel One: Oil Pressure below 30 PSI
Text Above Warning Channel One: OILP
Warning Channel Two: Engine RPM above 1000
Text Above Warning Channel Two: TACH
Text To Display When Warning Values Are Met: OILP
When at least one programmed warning channel is activated, the warning text will alternate between the
warning channel data and the normal display page data once per second.
To clear ALL active warnings, enter a SHORT press on Programming Button 1. This will clear the warnings
until the warning channel goes out of warning and then back into to warning again.
Primary Warning Channel
Warning Light
Primary Channel Text
Secondary Channel Text
Secondary Warning Channel
Warning Text