Step 2
A
Pull back the black quick release latch and push the
arm up. Put roll on the arm. The Chip2Go recognizes
automatically whether it has to program single or duo
transponders based on the transponders being used.
B
Push down the brake and thread liner through
machine as shown.
C
Pull the liner through until the first transponder is just
visible but not covering the programming antenna.
D
Push “Feed” and put liner through the upper slit as
shown on the picture, until the liner is grabbed and a
transponder is positioned on the programming antenna.
Stop here.
Transponder must not cover
the progamming antenna.
Step 1
Insert power cable at the
rear of the machine and
secure.
The Chip2Go will boot
automatically.
Quick Start Guide Chip2Go
A
B
C
D
