RACCEWAY E-MOPED, User Manual

Page: 14 / 64

MAINTENANCE
ATTENTION:
To carry out maintenance, first switch off the electric scooter and remove the ignition key.
Regular check:
Regularly check the condition of your electric scooter and make regular checks for proper tire
inflation, check the sensitivity of the brakes, tighten all components, and make sure they do not
make any unusual noise or abnormal noise when driving.
Brake adjustment:
Proper adjustment of the brakes will promote the correct operation of the warning lights and
increase driver safety:
The brakes are adjusted in a similar way to each norma I wheel. lt is important that the brakes work
properly and that the electrical disconnect devices are in working order (cable to the brake levers).
There is a micro-adjustable rear drum brake nut that allows you to very easily adjust the response of
the brakes to the push.
Once the brakes are set, turn the wheels to see if there is any chafing. Also make sure that if any of
the brakes is pressed, the power cut function will be activated and the motorwill stop.
Lubrication:
To ensure the long life of your electric scooter, the following components should be regularly
lubricated every 6 months:
Front axle; cha in; rear axle; the idle, front fork and other moving parts must be lubricated only with
grease and the brake must not be filled with grease at all.
Electrical components do not need to be specially cleaned as they have been lubricated at the
factory. lf any defect is found, contact an authorized service center.
Cleaning:
The electric scooter should be cleaned with a damp sponge, but care should be taken to avoid
electrical parts coming into contact with water (battery connection, engine (rear axle), electrical
cables, handlebar controls, etc.). Dry with a cloth.
Do not use a strong stream of water when cleaning the electric scooter. Use cloth to avoid short
circuiting electrical components. Your electric scooter is durable and does not require waxing. lf
necessary, clean with a mild detergent and rinse aid to restore its original shine.
TROUBLESHOOTING
PROBLEMS POSSIBLE CAUSES SOLUTIONS
lf you turn the switch to the ON position,
The battery is completely discharged.
Charge the battery.
the battery indicator does not light. The
The battery connection cable is loose.
Secure the cable.
engine is not working, there is no power
The fuse is blown.
Replace the fuse.
to the electric scooter.
The circuit breaker is in the OFF.
Set to ON.
Battery connected. lf the throttle is Battery charge too low. Fully charge the battery.
moved, the engine is not working ar its
Problem with the throttle. Replace the throttle handle.
maximum speed is limited.
The motor wiring is loose. Contact service.
The driving distance becomes shorter.
lnsufficient battery capacity.
Fully charge the battery.
Aging battery.
Replace the battery.
Tires are underinflated.
lnflate the tires.
Frequent braking, uphill ar against the
Use pedals more often.
wind driving.
The charging indicator does not light up The connection cable has come loose.
Secure the cable tightly.
when charging. The fuse is blown.
Replace the fuse.
The charger is damaged.
Replace the charger.
Other problems.
Problems with electrical components. Contact an authorized service center.
13