Rabbit RabbitCore RCM5400W, User Manual, Page: 26 / 120

20 RabbitCore RCM5400W
3.2 Sample Programs
Of the many sample programs included with Dynamic C, several are specific to the
RCM5400W modules. These programs will be found in the
SAMPLES\RCM5400W
folder.
•
CONTROLLED.C
—Demonstrates use of the digital outputs by having you turn LEDs
DS2 and DS3 on the Prototyping Board on or off from the STDIO window on your PC.
Parallel Port B bit 2 = LED DS2
Parallel Port B bit 3 = LED DS3
Once you compile and run
CONTROLLED.C
, the following display will appear in the
Dynamic C
STDIO
window.
Press “2” or “3” on your keyboard to select LED DS2 or DS3 on the Prototyping
Board. Then follow the prompt in the Dynamic C
STDIO window to turn the LED ON
or OFF. A logic low will light up the LED you selected.
•
FLASHLED1.C
—demonstrates the use of assembly language to flash LEDs DS2 and
DS3 on the Prototyping Board at different rates. Once you have compiled and run this
program, LEDs DS2 and DS3 will flash on/off at different rates.
•
FLASHLED2.C
—demonstrates the use of cofunctions and costatements to flash LEDs
DS2 and DS3 on the Prototyping Board at different rates. Once you have compiled and
run this program, LEDs DS2 and DS3 will flash on/off at different rates.