RAB Lightcloud Controller Mini, Manual, Page: 8 / 8

Setup & Installation
(cont’d)
2
Install your Lightcloud Controller
0-10V DIMMING
NOTE: The National Electrical Code requires that low-voltage wiring used in
the same enclosure as high-voltage wiring have an equal or better insulation
rating. You may need to complete your low-voltage wiring in another
enclosure or use a partition.
0-10V is a common method of low-voltage control of dimmable
drivers and ballasts.
Purple:
0-10V positive |
Gray:
0-10V common
2a
Install at a Junction Box (Indoor/Outdoor)
2b
At Lighting Panel or Trough
Space and code allowing, you may install Lightcloud devices directly
in your breaker box or lighting panel. Alternatively, break out lighting
circuits and install Lightcloud devices in a separate trough.
Controller requires constant, unswitched power.
!
When power switch
is set to OFF
Controller is disconnected
from network
OFF
POWER LOAD
DON’T
Controller always has power and is
connected to the network
POWER LOAD
DO
WHITE
BLACK
Controller Mini
Lightcloud ®
RED
WHITE
BLACK
BLACK
GRAY
PURPLE
To Load
To
P
ane
l
To
Dr
ive
r/
Ba
lla
st
MODULAR CABLE