YARD BLASTER INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting
fixtures. Our aim is to design the
best quality products to get the job
done right. We’d like to hear your
comments. Call the Marketing
Department at 888.RAB-1000, or
email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
R
AB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. This product must be installed in accordance with the applicable installation code by
a person familiar with the construction and operation of the product and the hazards involved.The YardBlaster is for
outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
WARNING:
Make certain power is OFF before installing or maintaining fixture.
LOCATION
Select a location on a structurally sound, flat wall or pole
10-25 feet from the ground. Fixture should be located on
wall or pole at least 18” below any overhang or other
structural detail.
Fixture should not be recessed.
MOUNTING
Wall Mounting
1. Using the mounting template as a guide, mark the 3
mounting holes. We suggest drilling 3/16” pilot holes
for lag screws (not provided).
2. Install the 2 bottom lag screws first. Screw in the lag
screws so that there is about 3/8” of space under the
head.
3. Place the fixutre on these 2 bottom lag screws. Install
the top lag screw then tighten the other 2 screws.
4. Secure the outdoor cable or flexible conduit to the
cover plate with a fitting in accordance with the
National Electric Code.
5. Install the coverplate and secure with the 2 screws
and nuts provided.
6. Install the reflector/lens assembly. Secure with the 2
screws and washers provided.
7. Install correct lamp provided.
YLM_YLS-IN-1210
