FFLED18 EMERGENCY INSTALLATION SHEET
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF and batteries are DISCONNECTED
before installing or maintaining fixture.
No user serviceable parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: [email protected]
Housing
Screws
Bracket Screw
Emergency
Batteries
Back Box Housing
Gasket
FFLED18/E
Battery
Connector
Gasket
Screws
Bracket
MOuNTING
CAUTION: Suitable as Wet Locations as Wall Mount.
1.
Loosen and remove (4)
Screws
and separate
Back
Box
from Emergency Housing. Use provided tether.
2.
Drill necessary holes on
Back Box
. Measurements
of drill positions are shown below.
3.
Match the hole pattern and place the
Gasket
on the
Back Box
.
4. Secure the
Back Box
on the surface with hardware
appropriate for the mounting surface.
5.
Wire the fixture to the incoming supply wires
according to NEC and local codes. Use UL listed
wire connectors.
6.
For FFLED18/E, each battery unit has one
connector. For FFLED18/EC, each battery unit has
two connectors as shown below. For details refer to
the appropriate Wiring Diagram section and supplied
Instruction Sheet.
7.
Connect the battery connectors. DO NOT connect
the
Batteries
before wiring the fixture to the supply.
8. Secure
Housing
to
Back Box
. Check
Housing
Gasket
seal all around.
9.
Apply sealant to all unused conduit entry points.
To ensure weatherproof seal, apply weatherproof
silicone sealant around the edge where the fixture
meets the wall. Seal arm thread using teflon tape or
silicone sealant.
Two connectors for
FFLED18/EC
