ENTRA 12 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
TM
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
FIXTURE MOUNTING
To ensure weatherproof seal, apply weatherproof silicone
sealant around the edge of the
Housing
and/or
Junction
Box
. This is especially important with an uneven wall surface.
Silicone all plugs and unused conduit entries.
MOUNTING TO JUNCTION BOX
1. Loosen
Door Screws
and open the
Door
. Screws will
remain in place with
Silicone Washers
.
2. Loosen
Reflector Screws
and slide the
Reflector
down
from the
Housing
.
3. Knock out appropriate
Slots
when mounting to junction
box (not supplied) and secure to
Junction box
.
4. Feed supply wires through
Junction Box.
Check the
Gasket
is fully sealed.
5. Make sure all gaskets are properly seated. Place the
Reflector
and tighten the
Reflector Screws.
Close and
tighten the
Door Screws
. Silicone all
Plugs
and unused
conduit entries.
MOUNTING TO WALL
1. Loosen
Door Screws
and open the
Door
. Screws will
remain in place with
Silicone Washers
.
2. Loosen
Reflector Screws
and slide the
Reflector
down
from the
Housing
.
3. Knock out appropriate
Slots
when mounting to the wall
surface.
4. Secure
Housing
to a sturdy wall. Use appropriate
mounting hardware such as lag bolts and anchors with
washers suitable for the mounting surface. Check the
Gasket
is fully sealed.
5. Make sure all gaskets are properly seated. Place the
Reflector
and tighten the
Reflector Screws.
Close and
tighten the
Door Screws
. Silicone all
Plugs
and unused
conduit entries.
6. If outdoor surface is irregular, use caulk to seal any gaps
around the
Housing
.
Housing
Gasket
Junction Box
(not supplied)
Door
Reflector
Silicone Washers (2)
Knock Out Slots
Reflector
Screws (2)
Door
Screws (2)
Plug
