ALED POST TOP INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
R
FIXTURE ASSEMBLY
1. Feed the (3)
Housing wires
through one of the three
Rods
.
2. Clip the (3)
Rods
onto the
Housing.
Be sure the
Housing
clips are properly engaged onto the
Rods
.
3. Feed
Fixture Wires
through the
Tenon Pole Adaptor.
4. Slide
Tenon Pole Adaptor
on three
Rods
. Be sure the
notches face the inside of the
Tenon Pole Adaptor
.
5. Tighten the (3) Set Screws at the
Tenon Pole Adaptor
to
secure
Rods
.
6. For 3” tenon use shorter tenon
Set Screw 5/8”
and for
2-3/8” tenon use
ALED
sleeve and hardware
to secure the
Housing
to tenon.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
Housing
Rods (3)
Tenon Pole
Adaptor
Set Screw
(to secure Rods)
Set Screw 5/8”
(to secure
3”Tenon)
POLE MOUNTING
1. Make the wiring connections with UL approved
connectors knot the wires for strain relief.
2.
Tenon Pole Adaptor
can fit tenon with 3” or 2 3/8”
diameter. Use ALED Sleeve if necessary for better fit.
ALED sleeve
