INSTALLATION INSTRUCTIONS
RAB DESIGN LIGHTING INC.
www.rabdesign.ca
1
WL-LED26
ELECTRICAL SHOCK HAZARD
READ, UNDERSTAND
, and
FOLLOW
these instructions
before installing the equipment.
WARNING
SAFETY
Proper grounding is required to ensure personal safety
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Min. 75
°
C supply conductors
Servicing this equipment should be performed by qualified service personnel.
Save these instructions
INSTALLATION
Remove the lens by removing the 4 screws that holds the lens
Remove the reflector by removing the 2 screws that holds the
reflector
Knock out appropriate holes around outlet hole in rear housing
Fasten the rear housing to the junction box using the screws
supplied with the junction box
Make appropriate wiring connections as per wiring diagram.
Ensure to use 90
°
C minimum rated wire connectors.
To ensure rain tight seal, apply silicone caulking around back
edges of the fixture
Reattach the reflector and the lens
WIRING
Check that the line voltage is correct.
Connect fixture
GROUND
(green) wire to power supply
GROUND
(green) wire.
Connect fixture
WHITE
wire to power supply
NEUTRAL
wire.
Connect fixture
BLACK
wire to power supply
LINE
wire
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
