28
BA_BM_ML-120_EN_12-23.docx
11.3.2
Remote Control Functions
Important: Before establishing the radio connection for the remote control, the supplied high-
flex antenna must be connected via BNC coupling to the receiver box (6) above the control cabi-
net.
Also make sure that the battery of the remote control is in a fully charged condition.
Action / State
Procedure / Description
Switch on the
remote control
To switch on, unlock the push but-
ton (
N
) by turning it to the left:
→
LEDs (
L7
) + (
L8
) are flashing
→
LED (
L1
) must be statically lit
Figure 10: Radio remote control
Operating state
LED (
LB
) lights up green:
→
Radio connection is established
→
Remote control is ready for use
LED (
LB
) flashes green:
→
Radio connection is interrupted,
no operational readiness!
LED (
LB
) lights up red
(a 3-fold beep is also heard):
→
Battery empty or capacity
≤ 10 %
Establish radio
connection
Note:
Connect the
high-flex antenna
to the receiver (
6
)
beforehand!
When LEDs (
L7
) + (
L8
) are flashing,
press buttons (
7
) + (
8
) together:
→
A beep sounds while the
buttons are pressed
→
As soon as the radio connection
is established, LED (
LB
) lights up
static green and LEDs (
L7
) + (
L8
)
go out
Lifting or lowering
the clamped load
1
→
Press button (
1
) or (
2
) until the desired position is reached.
Tilting the load
forwards or back
1
→
Press button (
3
) or (
4
) until the desired tilt angle is reached
Release the
clamped load
For safety reasons, this procedure is carried out via a time-controlled 2-button
switching sequence
→
Press button (
5
) twice within one second and press
button (
6
) once within another second.
→
The load is released immediately!
Risk of injury when releasing! Keep hands, body parts or persons under the
load area away while pressing the buttons (5) + (6)!
Switching off
after work
→
Press push button (
N
) to switch off and lock the remote control
Charge battery
The charging station for the remote control battery is permanently active, even if the
main switch is switched off. This means that charging is possible at any time.
Emergency stop
function
The push button (
N
) is also used to stop the drives immediately in case of emergency.
The power supply to the vacuum unit is maintained to prevent a plate from falling.
Restart after
switching off via
main switch or
push-button (N)
If the remote control is to be put back into operation after being switched off via the
main switch (
Figure 6) or push button (
N
), the radio connection must be re-estab-
lished. When switching on, the LEDs (
L7
) + (
L8
) flash and the LED (
L1
) next to the but-
ton (
1
) must light up statically. If another LED next to another button lights up instead,
the radio connection cannot be established.
→
Then press the button next to the lit LED once and then press button (
1
).
1
Note:
The height and tilt adjustment can be carried out simultaneously.
1
3
5
7
2
4
6
8
L8
LB
N
L7
L1