Qvidium QVDEC4K, User Manual, Page: 13 / 34

User Manual v.1 QVidium
®
QVDEC4K™ UHD/HEVC Video Decoder
Copyright 2023 QVidium
®
Technologies, Inc. Page 13 of 34
2
Decoder Configuration
You can configure and operate the decoder from a web browser. From the Decode menu, you can
create, start, edit, and delete a multitude of profiles that save the decoder parameters to allow you
to quickly restart the QVDEC4K in various configurations and applications, and shown in the
following screen shot.
All settings are stored in non-volatile flash memory, allowing the decoder to automatically recover
after a power failure. This section explains how to configure the QVDEC4K decoding parameters
with full access to the capabilities of the decoder
.
2.1 Quickstart Decoder Configuration
Below is a simple procedure to quickly start streaming from a compatible encoder to a QVDEC4K
decoder for decoding and displaying a video stream.
1. Enter
http://<IPAddress>
where <
IPAddress>
is the IP address of the QVidium
QVDEC4K
™ HEVC UHD-HDR Video Decoder that you want to configure as a decoder. (See
section 1.2 Network Settings1.2 to get or set the IP address.)
2. Click Decode from the menu on the left. Then, either click to highlight an existing decoder
profile you wish to edit and click Edit , or click Create
or “
+
” to create a new decoder profile.
The
“
Decoder Profile
” interface should then display in the main area to the right of the
menu system, as shown in Figure 2.
3. At this point, the web interface displays a list of all the configurable video and audio decoding
parameters, We recommend that you initially use all of the defaut settings for these
parameters, unless there is an obvious change required for your application.
4. Next click on Main Feed from last setting in the parameter list. Click to select the desired
video transport protocol, and enter the source
UDP port. For “Caller Mode” (aka. “Pull Mode”),
you must also enter the IP address of the encoder or video server.
Figure 1. Sample Decoder Profiles Page