QVI Cobra DRS-300, User Manual

Page: 60 / 100

How to Perform a Scan: Scanning a Penny
This sub-section includes a tutorial on how to create a profile by scanning a
penny. This tutorial is intended to familiarize you with the basic functions of
Scan-X and help you become familiar with the Cobra motion controls.
In this tutorial you will:
•
Position a penny, focus the laser sensor, and set scan controls
•
Scan a penny to create a profile
•
Collect height and length measurement results
•
Save the measurement results from the laser scan
•
View the measurement results from the laser scan
This tutorial is also documented in the Scan-X on-line help. To access this
procedure follow the steps below.
1. Access Scan-X, as described earlier.
2. In the Help menu, select Scan-X Help .
3. Click on the
Contents
tab.
4. Double-click on the book, Scan-X Coach: How to Scan a Penny .
5. Double-click on the topic, Introduction to Scan-X Coach .
-
Follow the instructions in the Coach to complete the exercise.
Getting Started 3-7
Getting
Started