Q150T Sample Preparation System
10473 - Issue 5
44
Q150T - Instruction Manual
6.2.1
Network
The Network category determines the IP address used by the instrument for Network
connections. To edit network properties, tap on
Network
and then tap on the
Edit
button.
The Network Properties are displayed (see
Figure 6-2
).
Figure 6-2.
Network properties
To set the instrument to use an IP address automatically generated by your DHCP
server, ensure that the
Automatic IP (DHCP)
parameter is set to
Yes
. If your network
does not have a configured DHCP server, you will need to set the IP address manually.
To set the IP address manually, set
Automatic IP (DHCP)
to
No
, then enter the primary
IP address and subnet mask address manually.
6.2.1.1 Connecting to a Network
To connect to a network:
Ensure that you have connected the instrument correctly to your network (see
Figure
6-3
).
Choose
Service | Connect Network
on the menu bar. A dialog box confirms that the
connection is active and shows its IP address.
Figure 6-3.
Active ftp address
Summary of Contents for Q150T S
Page 92: ......
