Quorum Q150T S, Instruction Manual

Page: 42 / 92

Q150T Sample Preparation System
10473 - Issue 5
42
Q150T - Instruction Manual
6 Instrument Management
The software controls the general operation of the instrument through a system of
default settings. This section describes how you can:
 Change general instrument settings
 Define the Network address and set up a connection
 Create user and group accounts
 Monitor the Film Thickness Monitor (FTM)

Adjust the instrument clock
6.1 The Q150T Menus
From the standby screen (see page 17), you can control the Q150T using commands
from the menu bar. Use the Edit menu to modify profiles and change the instrument
setup; use the Service menu to set the system clock, monitor FTM usage, and connect
the Q150T to a network. The Help menu displays version information about the Q150T
software.
Table 12 Q150T Menus
Menu Sub-menu Command Purpose
Edit Profiles Create, edit or delete profiles (see page 21)
Edit Materials Create, edit or delete coating parameters for
specific metals or alloys (see page 25)
Edit System Change hardware settings in System Editor
(see below)
Edit User Level Change user group/login privilege level (see
page 49)
Edit User Groups Create, edit or delete user groups and
passwords (see page 50)
Service FTM Monitor FTM usage (see page 51)
Service Set Time Set instrument clock (see page 51)
Service System Engineer use only
Service Connect
Network Connect Q150T to local network
(see page 44)
Help About Software version information
Help Information