Quincy QSV 2200, Instruction Manual

Page: 83 / 124

Section VI – Operating instructions
Quincy Vacuum Pump-QSV Series 83
Checking the display
Control panel Airlogic Graphic
Check the display (2) regularly for readings and messages. The display normally shows the vacuum pump
vacuum pressure, while the status of the vacuum pump is indicated by means of a number of icons.
Remedy the trouble if alarm LED (7) is lit or flashes, see section Icons used. The display (2) will show a
service message if a service plan interval has been exceeded or if a service level for a monitored
component has been exceeded.
Carry out the service actions of the indicated plans or replace the component and reset the relevant timer,
see section Service menu.
6.4 Taking out of operation

Disconnect the vacuum pump from the mains.

Shut off and vent the part of the system which is connected to the vacuum pump by opening the plug
located on the lit of the air inlet filter. Isolate the vacuum pump from the vacuum system.

Drain the oil.
6.5 Stopping

Press stop button (13). Automatic operation LED (7) goes out and the vacuum pump stops.

To stop the vacuum pump in the event of an emergency, press emergency stop button (S3).Alarm LED
flashes (4).

Remedy the problem cause, unlock the button by pulling it out.

Navigate to the Stop icon on the display by means of the navigation keys or scroll keys (12) and press
the Select key.

Press Reset .
Do not use emergency stop button (S3) for normal stopping!

Close the air inlet valve.

Switch off the voltage.