-
6
-
t
l
u
a
f
e
D
a
t
a
d
e
l
b
a
t
t
e
S
n
o
i
t
c
n
u
F
r
e
t
e
m
a
r
a
P
Request for maintenance
: disabled
Programming maintenance
cycles in thousands
Programming maintenance
cycles in millions
.
.
.
AUX output
: scheduled maintenance required
: photocell triggering
: obstacle detection
: PDM contact actuated
: bollard closed
: bollard open
: stop contact actuated
: start contact
: open contact
: blackout (the contact is activated when turned on)
: assistance required
TERMON
: motor temperature increase in °C
Deceleration rotation torque
(not available for
QK-CT273600L/ 800L/ K4)
Exiting the menu/saving
Exit programming and view machine Statuses
(see notes
automation
Statuses display after the 1st level table)
7.3
2nd LEVEL
PROGRAMMING
The following table gives the 2nd level functions and the single settable parameters.
If the vehicle is on the detector or in front of the photocell it does not cause immediate closing but rather you have to wait for
the signal to be released.
-
: The close command acts as a release closing and safety function.
When closing, the close command engaging stops the automation. When disengaged the bollard resumes closing.
·
: Default
- To reset the default parameters, set parameter
on 1 and exit the menu’.
A
,
B
,
C
and
D
, set the corresponding
default and quit the menu. See chapter 12 for details on installation type.
·
: Automation statuses display
d.
The statuses are:
: Idle
: Opening
: Stop opening limit switch
: Stop opening
: Closing
: Stop closing limit switch
: Stop closing
: Stop due to photocell triggering
: Opening due to photocell triggering
: Photocell triggering pause
: Stop due to a detected obstacle
: Opening due to a detected obstacle
: Obstacle detection pause
: Maximum working time in opening reached
: Maximum working time in closing reached
Description of level 2 parameters
·
: Request for maintenance
-
: the request for maintenance is not active.
-
: at the end of the countdown period, timed by the counters
and
, the programmed output is activated (
see parameter
)
-
: at the end of the countdown period, timed by the counters
and
, the programmed output is activated (
see parameter
Summary of Contents for QK-CE220CTN
Page 1: ...QK CE220CTN 1 3 V05 2014 ...