quiko QK-CE220CTN, Installation And Operation Manual, Page: 5 / 16

- 3 -
-level 1.
FTC
N.C. safety input (photocell). Enter the programme wanted by programming the -level 1 parameter. It triggers only in
the closing phase; it never triggers in opening.
STOP
N.C. safety input. When it is activated, the automation is immediately stopped. During the pause time, a stop control
eliminates the automatic closing, leaving the bollard open waiting for a command.
FCA
Opening limit switch NC.
FCC (for QK-CT273600L / 800L/K4 only)
FTC
COM
S
T
OP
COM
FCA
COM
FCC
COM
Closing limit switch. Select limit switch type (NO or NC) with parameter PP (paragraph 7.4)
START
N.O. input that operates the bollard’s opening and closing. The command is ignored while opening.
PDM
Input programmable with -level 3, -level 3 and -level 2 parameters. May be duplicated in AUX output.
OPEN
N.O. input - opening only.
By keeping this input controlled, the automation performs the opening manoeuvre and will close automatically only when
the input is freed. Connect clocks, daily timers or weekly timers here if wanted.
CLOSE
N.O. input for closing. It allows the automation to be closed only if the safety devices have not triggered. Operating
mode programmable with parameter
6.4 INPUTS/OUTPUT TERMINAL BLOCK
ST
ART
COM
PDM
COM
OPEN COM
CLOSE
COM
6.5
J10
ELECTRIC BRAKE TERMINAL BOARD/ANTENNA
EF Electric brake output (not available for QK-CT273600L/ 800L/ K4)
Connection for two white power supply cables for the motor’s parking electric brake.
Activation is possible only when the bollard is completely lifted (12/ 24Vdc).
BT Input for anti blackout electric brake feeder (not available for QK-CT273600L/ 800L/ K4)
Permits the continuous power supply of the electric brake even without electrical energy, preventing the bollard
from lowering spontaneously in case of a blackout. Do not connect the batteries directly to this input but request
the original accessory QK-BPACKCT.
EF
BAT
+
SHIELD
ANT