1- BEFORE INSTALLING THE AUTOMATION
Before installing the automation, you must check that:
WARNING: I
MPORTANT SAFETY INSTRUCTIONS
.
Follow
all
instructions
since
incorrect
installation can lead to severe injury
to people, animals or
things
.
Warnings and instructions provide important
information regarding safety, installation, use and maintenance.
GENERAL PRECAUTIONS FOR INSTALLERS
-
Safe
handl
ing of
drive and other parts weighing more than 20 kg by the use of proper handling
means,
such as hooks and ropes
-
that entrapment between the driven part and the surrounding fixed parts due to the opening movement
of the
boom
is avoided
. A minimum distance of 50cm between both ends of the driven part of the
appliance and sorrounding structures or obstacles must be respected.
-
the actuating member of a biased-off switch is to be located within direct sight of the driven part but
away
from moving parts. Unless it is key operated, it is to be installed at a minimum height of 1,5 m and
not
accessible to the public
-
the temperature range marked on the drive is suitable for the location;
-
All the protective devices comply to EN 12978, latest edition;
-
Electro-sensitive protective equipment shall be accessible for inspection purposes after installation;
-
you have all the tools, materials and safety devices you will need for moving and installing the appliance
in total safety in compliance with applicable regulations;
-
the installation and movement of the appliance is done respecting the needed safe distances in order to
protect fingers, hands, feet and body;
-
a switch is incorporated in the fixed wiring in accordance with the wiring rules in order to allow
disconnection of the appliance from the power supply after installation;
-
the earth system has been installed correctly: earth all the metal parts belonging to the entry system
(doors, gates, etc.) and all parts of the system featuring an earth terminal.
-
the power cable is properly stripped to allow the earth wire to be connected to the relevant terminal, while
leaving the live wires as short as possible. The earth wire must be the last to be pulled out in the event
the cable’s fastening device comes loose.
2-
AFTER
INSTALLING THE AUTOMATION
After
installing the automation, you must check that:
−
that the mechanism is properly adjusted and that the protection system and any manual release function
correctly
and that all requirements of EN 12604 and EN 12453 are still met;
−
the label concerning the manual release, adjacent to its actuating member is permanently fixed
;
−
fixed wirings which may come in contact with sharp edges or high temperature parts are properly
protected by insulating sleeving having an appropiate temperature rating;
−
the boom is in good mechanical condition, properly and correctly balanced adopting all information
given in the installation manual;
−
before to put it in operation, forces developed by the barrier shall be measured according to the
standard EN 12453, Annex C (Force measuring method) and fulfill admisible values of force. The
points where the forces have to be measured are specified in Annex C.10. The measurements shall
be performed on a complete barrier, fully equipped with all safety devices incorporated and adjusted
as specified in this user manual.
WARNING
: Do not use spare parts or accessories not indicated by Quiko Italy Srl. Their use and/or
incorrect re-assembly leads to loss of conformity and injury to people, animals and property.
Quiko Italy S
rl
Quiko Italy S
rl