ipv6 address
{
ipv6-address prefix-length
|
ipv6-address
/
prefix-length
} or
ipv6
address
{
ipv6-address prefix-length
|
ipv6-address
/
prefix-length
}
eui-64
The global unicast address is configured on the interface.
----End
5.3.5 Checking the Configuration
Prerequisite
All configurations of the IPv6 address are complete.
Procedure
l
Run the
display ipv6 interface
[
interface-type
interface-number
|
brief
] command to
check IPv6 information about the interface.
l
Run the
display ipv6 statistics
command to view statistics on IPv6 packets.
----End
5.4 Configuring IPv6 Neighbor Discovery
IPv6 neighbor discovery (ND) is a packet transmission process to identify the relationship
between neighboring nodes. The Neighbor Discovery Protocol (NDP) replaces the Address
Resolution Protocol (ARP), ICMP Device Discovery messages, and ICMP Redirect messages,
and introduces neighbor reachability detection.
5.4.1 Establishing the Configuration Task
This section describes the applicable environment, pre-configuration tasks, data preparation, and
configuration procedure for IPv6 neighbor discovery.
Applicable Environment
Most of the ND configurations are implemented based on the interfaces.
Pre-configuration Tasks
Before configuring IPv6 neighbor discovery, complete the following tasks:
l
Configuring the physical features for the interface and ensuring that the status of the
physical layer of the interface is Up
l
Configuring link layer parameters for the interface
l
Configuring the IPv6 address for the interface
Data Preparation
To configure IPv6 neighbor discovery, you need the following data.
Quidway S2700 Series Ethernet Switches
Configuration Guide - IP Service
5 Basic Configurations of IPv6
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62