Getting Started
18
QL-800 User Guide
Loading and Unloading Media
Loading Media
Note:
If you are using gap media with wide gaps between labels, special handling
instructions may apply.
See “Working with Wide Gap Media” on page 22.
1
Turn the wing nut [1] on the end of the mandrel counterclockwise to loosen the
mandrel.
2
Loosen the fastener on the outer flange [4]. Then remove the outer flange from the
mandrel.
3
Orient the media roll [2] as illustrated and put it on the mandrel. Make sure the roll
makes contact with the inner flange [3].
4
Turn the wing nut [1] on the end of the mandrel clockwise until you feel resistance.
This secures the roll in place.
5
Put the outer flange [4] on the mandrel. Make sure the outer flange makes contact
with the roll [2].
6
Tighten the fastener on the outer flange [4] until you feel resistance. This secures
the outer flange in place.
7
On the front of the printer, slide the media exit guide [5] all the way to the right
toward the control panel. You can adjust this guide before printing.
[1]
[2]
[4]
[3]
[5]
Summary of Contents for QL800
Page 2: ......
Page 10: ......
Page 14: ...Contents iv QL 800 User Guide...
Page 86: ...Printer Maintenance 72 QL 800 User Guide...
