Safety
QL-300 User Guide
461
19
Maintenance
Carefully read
User Guide
L
CAUTION
There is a risk
that hands may
touch the cutter
blade and be cut
while disman-
tling the cutter
unit of the
unwinder and
washing the cut-
ter blade.
Confirm the pro-
cedure for
cleaning before
you dismantle
the cutter unit
and wash the
cutter blade.
20
Usage
Carefully read
User Guide
M
CAUTION
There is a risk of
injury if the roll
paper is
dropped or over-
turned.
Workers must
wear rubber
gloves or simi-
lar gloves while
installing or
removing roll
paper.
Workers must
confirm the stor-
age and installa-
tion procedures
so they do not
drop or overturn
the roll paper.
21
Usage
Carefully read
User Guide
M
CAUTION
There is a risk
that hands could
be cut on the
edge of roll
paper.
Workers must
wear rubber
gloves or simi-
lar gloves while
handling roll
paper.
No
Job
Qualifications
and training
needed for job
Location
on
machine
Extent of
hazard
Description of
hazard
Protective
measures
implemented
by machine
installer and
user
Summary of Contents for QL-300
