QuickLabel Systems pronto! 486, User Manual

Page: 231 / 256

Pronto! 482/486/682/863 15-7
1 Insert original medium.
2 Press the menu button.
3 Select Memory card > Copy memory card with the right and left arrow
buttons.
4 Press the
↵
button.
A selection field with the selection No appears in the display.
5 Use the up and down arrow buttons to select Yes.
6 Press the
↵
button.
7 If the function Copy memory card is protected via a PIN, use the arrow
buttons to enter the code number and confirm with the
↵
button.
The copying procedure starts. When copying larger amounts of data, the
copying procedure is carried out in several copying cycles. An increasing
progress indicator is shown in the display during a copy cycle. The Insert
dest. instruction then appears.
8 Remove original medium and insert the medium to be written to.
The data read from the original medium is transferred to the copy
medium. The progress indicator in the display shrinks during this
process. If only part of the data from the original card was read out, the
Insert source instruction appears.
9 Remove copy medium and insert original medium again.
The next copy cycle begins.
10 Repeat the previous two steps until all data has been copied.
OK is shown in the display when the entire copying procedure is
complete.
11 Press the
↵
button.
If the medium to be written to can no longer accept data during the copying
procedure, the Card full error message appears in the display.
Format card
The Format card function can be used to delete all data from a memory
medium. This reformats the memory medium. This is why you can also use
the Format card function if the Unknown card or Structural err. error message
was output when using the medium.