QuickJack 3500SLX, Setup And Operation Manual

Page: 36 / 144

QuickJack™ Portable Car Jack
36
P/N 5900263 — Rev. B6 —September 2023
Operation
This section describes how to operate your QuickJack. This manual must delivered to the
owner/user/employer and be kept near the QuickJack.
QuickJack recommends using
Vehicle Lifting Points for Frame-Engaging Lifts for proper positioning of
Vehicles on your QuickJack. It shows the factory-recommended Lifting Points for a wide variety of
Vehicles. It is available on the ALI website .
QuickJack also recommends SAE Standard J2184,
Vehicle Lift Points for Service Garage Lifting
, as a
resource to assist you in the proper positioning of a Vehicle for raising.
⚠
WARNING Make sure to properly position each Vehicle on its factory-recommended Lifting
Points. Improper positioning of a Vehicle on the QuickJack could potentially lead to
the vehicle falling off. This could cause damage to the Vehicle, the QuickJack, and
potential injury to anyone nearby. Do not use QuickJack on slippery or icy floors.
Safety
Before you raise or lower a Vehicle using your QuickJack:
•
Check the QuickJack . Check the QuickJack Frames for any missing, heavily worn, or
damaged parts. Make sure the Lift Blocks are in their Receiver Trays. Do not operate the
QuickJack if you find any issues; instead, stop using it, then visit quickjack.com/support , email
support@quickjack.com , or call (888) 262-3880 .
• Check the area . Check the area around the QuickJack for obstructions; anything that might
impact the raising or lowering of the Vehicle. Do not forget to check above the QuickJack. If you
find an obstruction, move it out of the way. Do not allow unauthorized people, children, or animals
near the QuickJack while it is being used.
• Check the Line of Sight . Verify the operator has a clear, unobstructed line of sight to both
Frames while lifting a vehicle with the QuickJack.
• Check the operators . Make sure everyone who is going to operate the QuickJack has been
trained in its use, has read the labels on the unit, is not under the influence of drugs or alcohol, and
has read the manual.
⚠
WARNING
When raising or lowering a QuickJack, the Operator must pay
attention and both Frames must be visible without obstructions!
A
common safety issue is lack of attention; for example, Operators must not be
looking at a smartphone.
•
Check for safety
. Make sure everyone who is going to be walking near the QuickJack is aware
of its presence and takes appropriate safety measures. When raising a Vehicle, always
leave the QuickJack engaged on a locking position . When lowering the QuickJack, do
not leave it until it is on the ground.
⚠
WARNING You must always use auxiliary safety stands under the Vehicle while elevated on
both QuickJack Frames.
⚠
WARNING Risk of explosion . The QuickJack Power Unit has arcing or sparking parts that
should not be exposed to flammable vapors. The Power Unit should be located at
least 460 mm (18 inches) above the floor.