SALSA/SALSA M
47
Rev.5.0
7.3 VR2 Dual control unit
Control button and indicator:
This shows which joystick has control. If the red wheelchair
light is on the wheelchair occupants joystick has control. If
the green attendant light is on the dual attendant systems
joystick has control. The button is used to transfer control
between the two choices
Actuator button and LED:
All VR2 dual attendant systems have an actuator button
fitted as standard.
NOTE:
If the VR2 is programmed with no actuators then
this button has no function.
Wheelchairs with one actuator:
Depressing the actuator button once will enter actuator
adjustment mode. This will be indicated by the illumination
of both actuator LED’s. Actuator adjustment can then be
made by deflecting the joystick forwards and backwards.
To re enter drive mode, depress either the actuator button
or the speed button
Wheelchairs with two actuators:
Depressing the actuator button will enter actuator adjustment
mode. Depressing the button once illuminates the left LED
and deflection of the joystick forwards or backwards will
adjust the actuator connected to that channel. Selection
between the two actuators is achieved by deflecting the
joystick to the left and right. As the actuator selected
changes so will the LED which illuminates. Left for actuator
1 and right for actuator 2
To re enter drive mode, depress either the actuator buttonor
the speed button
Maximum speed button and indicator:
This shows the maximum speed setting for the
wheelchair
when the dual attendant system has control. There are five
settings - setting 1 is the slowest speed and setting 5 is
the highest speed. The speed setting is changed with the
speed button.
NOTE:
If the control system is programmed for drive profile
operation, then the dual attendant system speed adjuster
will only adjust the speed within the selected profile.
NOTE:
Changing between drive profiles can only be
achieved using the VR2
R-net Control
Please refer to your R-net Owner’s Manual for
details.
