13
Rev. B English
Q50 R Carbon
4.0 Setting up the wheelchair
4.1 Assembling
Open the packaging box, take out the wheelchair and remove
the protective padding. Firstly open the footrest, take out the
battery and insert it fully into the battery rail. When you hear
a “click”, this indicates the battery is installed in place (Fig.
4.1 - 4.2). Release Velcro strap wrapped around push handle
(Fig.4.3 - 4.4). Then with one hand on the seat cushion and
one on the backrest, unfold the wheelchair. (Fig. 4.5 - 4.6).
When you hear another “click”, it indicates that the latch has
fixed onto the locking pin (Fig. 4.7), and the wheelchair has
been unfolded.
WARNING!
When inserting the battery, make sure that the battery clip
has clicked into place to prevent the battery falling out. If it is
difficult to insert the fixing clip into the battery, you can pull
the fixing clip open by hand, then insert the battery. Please
make sure that the clip “clicks” into place.
WARNING!
After unfolding the wheelchair, please check the latch has
located and secured the backrest locking pin (Fig. 4.7). Please
only sit in the wheelchair once this has been fixed. Otherwise,
it will damage the wheelchair and could cause personal injury.
Fig. 4.1
Fig. 4.3
Fig. 4.5
Fig. 4.4
Fig. 4.6
Fig. 4.2
Fig. 4.7
Summary of Contents for Q50 R Carbon
Page 77: ...77 Rev B Q50 R Carbon...
Page 78: ...78 Rev B Q50 R Carbon...
Page 79: ...79 Rev B Q50 R Carbon...
