M12 Hardware Design
M12_Hardware_Design_V3.3
- 34 -
3.5.1. Minimum functionality mode
Minimum functionality mode reduces the functionality of the module to minimum level, thus
minimize the current consumption when the slow clocking mode is activated at the same time.
This mode is set with the “AT+CFUN” command which provides the choice of the functionality
levels <fun>=0
，
1
，
4.
0: minimum functionality
1: full functionality (default)
4: disable both transmitting and receiving of RF part
If the module is set to minimum functionality by “AT+CFUN=0”, the RF function and SIM card
function would be closed. In this case, the serial port is still accessible, but all AT commands
correlative with RF function or SIM card function will not be accessible.
If the module has been set by “AT+CFUN=4”, the RF function will be closed, the serial port is
still active. In this case, all AT commands correlative with RF function will not be accessible.
After the module is set by “AT+CFUN=0” or “AT+CFUN=4”, it can return to full functionality
by “AT+CFUN=1”.
For detailed information about “AT+CFUN”, please refer to
document [1]
.
3.5.2. SLEEP mode (slow clock mode)
The SLEEP mode is disabled in default software configuration. Customer’s application can enable
this mode by “AT+QSCLK=1”. On the other hand, the default setting is “AT+QSCLK=0” and in
this mode, the module can not enter SLEEP mode.
When “AT+QSCLK=1” is set to the module, customer’s application can control the module to
enter or exit from the SLEEP mode through pin DTR. When DTR is set to high level, and there is
no on-air or hardware interrupt such as GPIO interrupt or data on serial port, the module will enter
SLEEP mode automatically. In this mode, the module can still receive voice, SMS or GPRS
paging from network but the serial port is not accessible.
3.5.3. Wake up module from SLEEP mode
When the module is in the SLEEP mode, the following methods can wake up the module.
If the DTR pin is pulled down to a low level, it will wake up the module from the SLEEP
mode. The serial port will be active about 20ms after DTR is changed to a low level.
Quectel
Confidential
