Quectel L26, Command Manual

Page: 6 / 29

GNSS Module Series
GNSS SDK Commands Manual
GNSS_SDK_Commands_Manual Confidential / Released 5 / 28
1
Introduction
Quectel GNSS modules support SDK commands which are defined and developed by Quectel. This
document describes these SDK commands. The configuration parameters saved by SDK commands will
still exist in flash even after upgrading the modules’ firmware.
This document is applicable to Quectel L70, L80, L76, L76-L, L86 and L26 modules. Their supported SDK
commands are shown in the table below:
Table 1: Current Supported SDK Commands
SDK
Commands
Description L70 L80 L76 L76-L L86 L26
PQBAUD Change NMEA Port Default Baud Rate Y Y Y Y Y Y
PQEPE Enable/Disable PQEPE Sentence Output Y Y Y Y Y Y
PQ1PPS
Set the Type and Pulse Width of 1PPS
Output
Y Y Y Y Y Y
PQFLP
Set the Module into FLP (Fitness Low
Power) Mode
Y Y N N N N
PQTXT Enable/Disable GPTXT Sentence Output N Y N N Y Y
PQECEF
Enable/Disable ECEFPOSVEL Sentence
Output
N N Y Y Y Y
PQODO Start/Stop Odometer Reading N N Y Y Y Y
PQPZ90
Enable/Disable Switching from WGS84 to
PZ-90.11
N N Y Y Y Y
PQGLP
Set the Module into GLP (GNSS Low
Power) Mode
N N Y Y Y Y
PQVEL
Enable/Disable 3 Ways Velocity Sentence
Output
N N Y Y Y Y
PQJAM
Enable/Disable Jamming Detection
Function
N N Y Y Y Y
PQRLM
Enable/Disable Return Link Message
Output
N N Y Y Y Y
PQGEO Configure Parameters of Geo-fence Y N Y Y Y Y
Quectel
Confidential