Quectel BG96, Developer'S Manual

Page: 38 / 90

General AT Commands for the Quectel
BG96 module
You can directly access the cloud and manage the Eseye-enabled Quectel BG96 module using AT
commands.
You can find a full set of the Quectel BG96 module AT commands here:
BG96 AT Commands Manual PDF
Use a terminal emulator to send test, read and write AT commands to the Quectel BG96 module. For
terminal emulator configuration information, see Connecting to the LTE IoT 2 click on page 3.
Before you begin
Before you use any Eseye-enabled AT commands on the modem, ensure that it is ready to receive
AT commands.
To test that the modem is ready to receive AT commands:
1. Using a terminal emulator that is connected to your modem, type:
at
<return>
The terminal emulator will return any of the following:
OK
– the modem is connected and ready to communicate with the host
ERROR
– the modem cannot communicate with the host. Contact the modem supplier.
Nothing – ensure you have set the correct baud rate in your terminal emulator. For more
information, see Connecting to the LTE IoT 2 click on page 3.
2. Type:
at+etminfo=version
<return>
The terminal emulator will return either of the following:
•
Eseye Telemetry Module V< version >
, where <
version
> is the current
software version – the modem is ready to receive AT commands. Verify that the
version number is
Eseye Telemetry Module V0.99_ma
or higher.
•
ERROR
– the modem is not ready to receive AT commands. The ETM software has not
yet initialised. Try again in 5 seconds.
31 Eseye-enabled Quectel BG96 module Developer Guide v1.8
General AT Commands for the Quectel BG96 module