Qubic System QS-CH2, User Manual

Page: 18 / 31

QS-CH2
3. INSTALLATION
3.1. SOFTWARE INSTALLATION
INFO
The base QS-CH1 requires MC6 controller set in order to connect it to the user PC
and install QubicManager.
The
SERIAL NUMBER
can be found on the M10 identification label in the
XXXXXX-XXXXXX-
XXXXX-XXXXXX
format. This serial number is also used for activation of FSMI (Force-
SeatMI) and MT (Motion Theater) licences.
To download the software visit :
QubicSystem.com/Download
Once the QS-CH2 is installed and connected correctly:
1.
Connect power supply cable to the wall socket.
2.
Download QubicManager.
3.
Proceed with the installation steps and launch the application.
4.
Turn on the system by switching on the power switch button on the QS-SB2 power
cabinet.
5.
The QS-CH2 will perform a start-up calibration.
WARNING
DO NOT
change the payload during the start-up calibration.
User Manual R1.0 13