Quasar CB-6204/CB-6208 User and Installation Guide
14
5.3
Power and Ethernet Cable Connection
Make sure the camera’s power cable is properly connected. Refer to
using Power over Ethernet (PoE), make sure Power Sourcing Equipment (PSE) is available on the
connected network. All electrical work must be performed in accordance with local regulatory
requirements.
5.4
Initial Camera Configuration
To perform the initial camera configuration
1.
Unpack the camera.
2.
Connect one end of the network Cat 5 Ethernet cable to the RJ45 connector on the camera’s
system cable.
3.
Connect the other end of the network cable to a Power Sourcing Equipment (PSE) device,
such as a switch.
4.
Verify that the LEDs on the RJ45 connector illuminate green (indicating a stable network
connection) and flashing yellow (to indicate network activity).
5.
Do the following:
a.
Copy and run
dna.exe
(see note below) from the included CD.
Note:
DNA is an enhanced software alternative to Device Search. Either of these
programs may be used. They are supplied on the included CD.
b.
Click the
icon.
c.
Select the unit requiring IP assignment.
Figure 14: Discovered IP Devices
d.
Right-click the mouse and select the assigned IP address or click the
Assign IP
button
to open the
DNA Assign IP
dialog box.
Note:
The camera default IP Address and the subnet mask IP Address are
automatically supplied by the DHCP server.
e.
In the dialog box that is displayed, enter values for the
IP Address, Gateway and
Netmask
.
f.
Click
Update
and wait for
OK
status to be displayed.
