Quantum ValueLoader DLT VS160, User Manual

Page: 48 / 88

ValueLoader Administration
Configuring the ValueLoader
34 ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
To access the
Configuration
menu from the Home screen or main menu,
press the
[+]
or
[–]
button until
Configuration
appears on the top line of the
LCD screen. Press the
[Enter]
button and then
[+]
or
[–]
to access the
available options. Press the
[Enter]
button to execute the displayed menu
option.
Resetting the
ValueLoader
3
This option resets the ValueLoader robotics and the tape drive within the
ValueLoader, forces a new cartridge inventory, and clears any current
error condition.
To access this option, follow these steps:
1 From the Home screen or main menu, press the
[+]
or
[–]
button until
Configuration
appears on the top line of the LCD screen.
2 Press
[Enter]
to select.
3 Press the
[+]
or
[–]
button until
Reset
appears on the LCD screen.
4 Press the
[Enter]
button to reset the ValueLoader.
After initialization, the ValueLoader returns to normal operation and
displays the Home screen.
Changing the SCSI
ID
3
This option changes the SCSI ID the ValueLoader uses. The ValueLoader
operates as a single SCSI device with two separate SCSI Logical Unit
Numbers (LUNs): one LUN (0) is for the tape drive, the other (1) is for the
ValueLoader robotics.
The default SCSI ID is 5. You should only need to change the SCSI ID if
there are other devices on the SCSI bus with the same SCSI ID.
Note: This option is primarily used if the ValueLoader is in an error
state.