Quantum TRU-BALANCE 3, Basic Operation Instructions

Page: 17 / 28

17 BASIC OPERATION INSTRUCTIONS
Figure 18. Controller Height Adjustment (Flip-up
Armrests)
Figure 19. Controller Height Adjustment (Two Post and
Heavy Duty Drop-in Armrests)
Figure 20. Cable Routing
To change the controller extension:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it
to the armrest.
3. Flip and then rotate the release lever to loosen the
clamp.
See figure 18 or 19.
4. Slide the controller into or out of the armrest to the
desired position.
5. Rotate and flip the release lever to tighten the clamp.
6. Route the controller harness to the back of the power
base and secure it with clips.
See figure 20.
To change the controller height:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it
to the armrest.
3. Flip and then rotate the release lever to loosen the
clamp.
See figure 18 or 19.
4. Adjust the controller to the desired height.
5. Rotate and flip the release lever to tighten the clamp.
6. Route the controller harness to the back of the power
base and secure it with clips.
See figure 20.
P-clip