Quantum Sun StorEdge L100, User Manual

Page: 82 / 192

Chapter 3 Changing the Library Configuration
Changing the Barcode Scanner Setting
66 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
Changing the Barcode Scanner Setting
3
The
Barcode Scanner
option controls whether the bar code scanner
is enabled or disabled. When the scanner is enabled, the library
attempts to detect a bar code on all tape cartridge labels. If the
correct bar code labels are not used, or if some cartridges are not
labeled, scanning time may be greatly increased. Therefore, it is
recommended that you disable the
Barcode Scanner
option if you
do not intend to use compatible bar code labels.
To enable or disable the
Barcode Scanner
option:
1
Access the
Configuration
screen (see Accessing the
Configuration Screen on page 53).
2
Press the
Up
or
Down
buttons until
Barcode Scanner
is
highlighted.
3
Press
Select
.
4
Use the
Up
or
Down
buttons to select the desired
Barcode
Scanner
setting. The available settings are
Enabled
and
Disabled
.
5
Press
Select
.
To return to the
Configuration
screen without changing the
option setting, press
Cancel
.
6
Press
Main
to return to the main screen.
Note:
The default setting is
Enabled
.
Caution:
If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note:
You must reboot the library before this setting will
take effect.