Procedure
Quantum Smart-1 6000-L/6000-XL Appliances Replacing SAN Cards | 13
Installing the Riser
Align the guide rails on the riser with the standoffs on the side of the system.
Lower the riser into the system until the riser connector engages with the connector on the system board.
Reassembling the Appliance
To reassemble the appliance:
1. Install the cover.
a. Make sure all internal cables are routed correctly and connected, and no tools or extra parts
are left inside the system.
b. Align the tabs on the cover with the guide slots on the appliance.
c. Push the latch down.
d. Slide the cover forward.
The tabs on the cover should engage with the guide slots on the appliance.
The latch should lock into place.
e. Use a flat or Phillips head screwdriver to rotate the latch release lock clockwise to the locked
position.
2. Install the appliance into the rack. See the
Installing the Quantum Smart-1 6000-L/6000-XL
booklet for illustrated installation procedures:
3. If you have transceivers for your expansion SAN card, install them now.
See
"Replacing a Transceiver" on the next page
.
If not, install them later.
4. If AC PSUs are installed in the appliance:
Connect the power cables from the AC PSUs.
