Quantum Scalar i6000, User Manual

Page: 526 / 738

Chapter 14: Using the Command Line Interface
Command Line Interface (CLI) Commands
508 Quantum Scalar i6000 User’s Guide
show library status
show library status
description: Shows the current library state and status of each component.
This command should show whether the library is online, offline, or inventorying. It should also show
whether each drive is loaded or not.
examples: show library status
/>sho lib stat
Component Status Description
------------------------ ------- -------------------------------------------------------
System Health Red Failed
Control Red Failed; Active events: 1
Event: 106 Red Chassis Management Blade(CMB) circuit card at [1,1,1,1,2](CMB ethernet
interface) has failed
Connectivity Green Operational
Power Green Operational
Cooling Red Failed; Active events: 5
Event: 1 Red Network Chassis fan in [1,8,1,1](CMB fan 1 speed sensor) is in the Low
Warning Range
Event: 2 Red Network Chassis fan in [1,1,1,1](CMB fan 1 speed sensor) is in the Low
Warning Range
Event: 3 Red Network Chassis fan in [1,7,1,1](CMB fan 1 speed sensor) is in the Low
Critical Range
Event: 4 Red Network Chassis fan in [1,4,1,1](CMB fan 1 speed sensor) is in the Low
Critical Range
Event: 5 Red Network Chassis fan in [1,3,1,1](CMB fan 1 speed sensor) is in the Low
Critical Range
Robotics Yellow Warning; Active events: 1
Event: 107 Yellow Front door switch hardware in Module 1 is open
Robot# 1 Red Not Ready; Manual Intervention Required
Drives Green Operational
Drive# 1 (P1 D1) Green Online; Drive Empty
Drive# 2 (P1 D2) Green Online; Drive Empty
Drive# 3 (P1 D3) Green Online; Drive Empty
.
. .
Drive# 94 (P1 D94) Green Online; Drive Empty
Drive# 95 (P1 D95) Green Online; Drive Empty
Drive# 96 (P1 D96) Green Online; Drive Empty